HOGUE PISTOL GRIP P220

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

Blaser sling swivel loop and pivot pin/screw.

Fits all Blaser rifles with fixed studs and will suit straps of up to 20mm x 3.5mm

Hogue rubber grips are molded from a durable synthetic rubber that is not spongy or tacky, but gives that soft recoil absorbing feel, without effecting accuracy. This modern rubber requires a completely different molding process than ordinary neoprene and results in a much superior grip. The material used does not come apart or deteriorate and is resistant to all solvents and oils used around firearms.

• P60 incandescent lamp assembly
• Produces 65 lumens of white light
• 1 Hour of runtime
• Do not use rechargeable LFP 123A batteries with the P60 lamp assembly or with other incandescent illumination tools

GLOCK OEM factory Recoil Spring Assembly fits G19, G23, G32, G38 (marked 5593 on end of recoil spring guide). For Generation 1, 2, and 3 pistols.

• Fits Vortex Viper/Venom micro red dot sight
• Fits Ade Advanced Optics rd3-001, rd3-02, rd3-009, rd3-006a, fits Sightmark mini shot reflex sight
• Fits Burris Fastfire micro red dot sight(Notes: the screws included in the package are not long enough for some Burris red dot sights, you can use the screws in the red dot)
• Caution: NOT fit RMR, RMS, Doctor.

Beretta Large Bradley Front Sight. This sight is standard on Beretta 682 Gold E, DT10 Competition, ASE Gold, and A400 Xcel models. This sight will fit any Beretta shotgun except old blade style models. This sight will fit other shotguns that use a 2.6x.45 front sight.

• Cartridge shell case size: Length is 6″. Width is 1″. Height is 4″.
• Close style ammo cartridge holder is made of quality waterproof nylon. Shooter`s pouch is equipped with 2 rows of elastic loops for 12 or 16 gauge shells and may accommodate up to 12 cartridges.
• This shotgun ammo wallet has two loops at the back to fix it on the belt. Accommodates belts up to 2 1/4 -Inch wide.
• Classic ammo holder for shotgun shells closes with snap buttons to keep your cartridges safe and dry.
• Belt ammo pouch is easy to clean and will keep rounds at hand.